Configure the alarm properties – Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module Manuel d'utilisation
Page 78
Advertising
78
Publication ICM-UM002F-EN-E - March 2013
Chapter 3 Configure XM Module in RSLogix 5000 Software
Configure the Alarm Properties
Use the Alarm tab to configure the alarms for the Dynamic Measurement
module. Each alarm supports two alarm levels (Alert level and Danger level).
The AOP supports six alarms.
1.
From the Module Properties dialog box, click the Alarm tab.
2.
Choose an alarm from the Alarm list. The Add-on Profile supports six
alarms.
3.
Configure the parameters, as necessary.
In this field
Values are
Comments
Alarm Name
Enter a descriptive name for the alarm.
The alarm name is not sent to the XM module.
Enable Alarm
Check to enable the alarm.
Clear to disable the alarm.
Advertising