Panel/wall mounting – Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module Manuel d'utilisation
Page 26
26
Publication ICM-UM002F-EN-E - March 2013
Chapter 2 Installing the XM Dynamic Measurement Module
4.
Press down on the terminal base unit to lock the terminal base on the
DIN rail.
If the terminal base does not lock into place, use a screwdriver or similar
device to open the locking tab, press down on the terminal base until
flush with the DIN rail and release the locking tab to lock the base in
place.
5.
Gently push the side connector into the side of the neighboring terminal
base to complete the backplane connection.
Panel/Wall Mounting
Installation on a wall or panel consists of:
• laying out the drilling points on the wall or panel
• drilling the pilot holes for the mounting screws
• installing the terminal base units and securing them to the wall or panel
Use the following steps to install the terminal base on a wall or panel.