Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 55)

55 Publication ICM-UM002F-EN-E - March 2013
55
Chapter
3
Configure XM Module in RSLogix 5000
Software
The RSLogix 5000 software Add-on Profile (AOP) lets you set up I/O
connections to your controller and configure the XM module. Read this
chapter for information about how to configure the 1440-DYN02-01RJ
module, using RSLogix 5000 software (Version 16 or later) and the
1440-ACNR ControlNet Adapter.
For more information about the ControlNet network, refer to ControlNet
Modules in Logix5000 Systems™, publication
CNET-UM001 .
Use the Help Button
Click Help at the bottom of the dialog box to get information about the entries
on the dialog boxes. Click Help in a warning dialog box to get information
about the specific error.
About the ControlNet
Adapter
The 1440-ACNR ControlNet Adapter allows XM modules to communicate
over the ControlNet network. The 1440-ACNR interfaces to a Logix
controller.
When RSLogix 5000 downloads the XM module configuration to a Logix
controller, the controller attempts to establish a direct connection to each XM
module in the I/O Configuration.
The controller maintains and monitors its connection with the XM module.
Any break in the connection, such as a module fault or removal of the module
while under power, causes the controller to set fault status bits in the Input Tag
associated with the module.
Topic Page
Use the Help Button 55
About the ControlNet Adapter 55
Add the XM Module to the I/O Configuration Tree 56
Add the XM Module to the I/O Configuration Tree 56
Configure Module Properties 59
Save Module Configuration and Download to the Controller 84
Schedule the I/O Module Connections 84
Access Module Data using the ACNR 84