Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 10)

10 Publication ICM-UM002F-EN-E - March 2013
Chapter 1 Introduction
Module Components
The Dynamic Measurement module consists of a terminal base unit and an
instrument module. The Dynamic Measurement module and terminal base are
shown below.
Figure 1.1 Module Components
• Dynamic Measurement Terminal Base - A DIN rail mounted base unit
that provides terminations for all field wiring required by the Dynamic
Measurement module.
• Dynamic Measurement Module - The module mounts only on the
1440-TBS-J terminal base via a keyswitch and a 96-pin connector. The
module contains the measurement electronics, and processors.
Figure 1.2 Mini-Connector
DYNAMIC MEASUREMENT 1440-DYN02-01RJ
31884-M
Dynamic Measurement Terminal Base Unit
Cat. No. 1440-TBS-J
Dynamic Measurement Module
Cat. No. 1440-DYN02-01RJ
IMPORTANT
The mini connector located under the label on the top of
the module is not used.
DYNAMIC MEASUREMENT
1440-DYN02-01RJ
mini-connector
(not used)