Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 64)

64 Publication ICM-UM002F-EN-E - March 2013
Chapter 3 Configure XM Module in RSLogix 5000 Software
3. When finished, click one of these as needed.
• OK - Click to accept your edits and close the dialog box.
• Cancel - Click to close the dialog box without accepting your edits.
• Apply - Click to accept and apply your edits on any dialog box and
continue editing.
Monitor and Reset the Module Status Information
Use the Module Info tab to view module and status information. You can also
reset the module to its power-up state from this tab. Note that the data on this
tab comes directly from the module when it is online.
1. From the Module Properties dialog box, click the Module Info tab.
2. Click Refresh to refresh tab with new data from the module.
3. Click Reset Module to return a module to its power-up state by
emulating the cycling of power.
Configure the Channel Properties
Use the Channel tab to define the characteristics of the transducer and the
signal processing performed on the input signals. The Dynamic Measurement
module has two input channels.