Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 25)

Publication ICM-UM002F-EN-E - March 2013 25
Installing the XM Dynamic Measurement Module Chapter 2
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail.
If the terminal base does not lock into place, use a screwdriver or similar
device to open the locking tab, press down on the terminal base until
flush with the DIN rail and release the locking tab to lock the base in
place.
Interconnecting Terminal Base Units
Follow the steps below to install another terminal base unit on the DIN rail.
1. Position the terminal base on the 35 x 7.5 mm DIN rail (A).
2. Make certain the side connector (B) is fully retracted into the base unit.
3. Slide the terminal base unit over tight against the neighboring terminal
base. Make sure the hook on the terminal base slides under the edge of
the terminal base unit.
31883-M
IMPORTANT
Terminal base units are mounted left to right on the DIN rail.