Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 72)

72 Publication ICM-UM002F-EN-E - March 2013
Chapter 3 Configure XM Module in RSLogix 5000 Software
Sampling Mode continued.
Frequency Maximum The maximum frequency or order for the spectrum
measurement. The sampling mode determines whether the
frequency maximum is specified in Hz or
orders. It also determines whether you enter a
value or choose a value from a list of available
values.
• If Sampling Mode is Synchronous with
tach, enter the Frequency Maximum value.
The frequency maximum range for
synchronous sampling mode is 4...200
orders.
• If Sampling Mode is Asynchronous, choose
the Frequency Maximum value. Note you
may enter a specific value if you choose 10
to 5000 range. Supported maximum
asynchronous frequencies are dependent
on sensitivity units and full scale units you
choose on the Channel tab. See tables
below.
In this field Values are Comments
Asynchronous Sampling Synchronous Sampling
The waveform
measurement is
time-based The waveform
measurement is
position-based.
The spectrum
measurement is
frequency-based. The spectrum
measurement is
order-based and the
Number of Lines must be
evenly divisible by
Frequency Maximum.
The Frequency Maximum
must be specified in Hz. Frequency Maximum must
be specified in orders.
Frequency A B
10 to 5000 X X
6250 X X
7500 X X
8000 X
9375 X X
10000 X
12500 X
15000 X
18750 X X
20000 X
Full Scale Units (Channel tab)
mil
µm in/s
mm/s
g V
Psi
mbar
Sensitivity
Units
(Channel
tab)
mil
µm
Column A
in/s
mm/s
Column A Column A
g Column B Column B Column A
V Column A
Psi
mbar
Column A