Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 47)

Publication ICM-UM002F-EN-E - March 2013 47
Installing the XM Dynamic Measurement Module Chapter 2
Figure 2.25 Three Non-contact Sensors Wiring
XM Bus Connection
The module includes an XM Bus connection that allows the module to
communicate with a Programmable Logic Controller (PLC), Distributed
Control System (DCS), or another XM module.
The XM Bus communicates using standard DeviceNet protocols but it does
not share the same specifications for the media (the wire) and isolation
characteristics.
IMPORTANT
Make certain the
Power parameter is set to -24V for both
channel 0 and channel 1 to set the buffered outputs to the
appropriate range.
See Configure the Channel Properties on
page 64 for details.
TYPICAL WIRING FOR THREE NON-CONTACT SENSOR
TO XM DYNAMIC MEASUREMENT MODULE
Shield
-24V DC
Shield
Floating
3
19 -24V DC