Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 49)

Publication ICM-UM002F-EN-E - March 2013 49
Installing the XM Dynamic Measurement Module Chapter 2
Mounting the Module
The Dynamic Measurement module mounts on a terminal base unit
(1440-TBS-J). We recommend that you insert the module after you have
connected the wiring on the terminal base unit.
ATTENTION
The Dynamic Measurement module is compatible only with the
1440-TBS-J terminal base unit. The keyswitch on the terminal
base unit should be at position 1 for the modules.
Do not attempt to install 1440-DYN02-01RJ module on
other terminal base units.
Do not change the position of the keyswitch after wiring
the terminal base.
WARNING
If you insert or remove the module while backplane power is on,
an electrical arc can occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
WARNING
If you connect or disconnect wiring while the field-side power
is on, an electrical arc can occur. This could cause an explosion
in hazardous location installations. Be sure that power is
removed or the area is nonhazardous before proceeding.
IMPORTANT
Install the overlay slide label to protect serial connector and
electronics when the serial port is not in use.