Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module Manuel d'utilisation
Page 45
Publication ICM-UM002F-EN-E - March 2013
45
Installing the XM Dynamic Measurement Module
Chapter 2
Connecting a Velocity Sensor and Two Non-Contact Sensors
The following figure shows the wiring of a velocity sensor and two
non-contact sensors to the terminal base unit. The first non-contact sensor is
wired to channel 0. The velocity sensor is wired to channel 1, and the other
non-contact sensor is wired to the tachometer input signal.
ATTENTION
You may ground the cable shield at either end of the cable. Do
not ground the shield at both ends. Recommended practice is to
ground the cable shield at the terminal base and not at the
transducer. Any convenient Functional Earth terminal may be
used. See
Terminal Block Assignments on page 28
.
IMPORTANT
Transducer DC bias is monitored on all signals.
IMPORTANT
Make certain the
Power parameter is set correctly for each
channel. Set channel 0
Power to -24V and set channel 1
Power to Bias Current.
See Configure the Channel Properties
for details.