Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 66)

66 Publication ICM-UM002F-EN-E - March 2013
Chapter 3 Configure XM Module in RSLogix 5000 Software
Nominal Sensitivity Choose the sensitivity of the transducer. Your choice controls the list of possible full
scale selections.
The default is 200.0 mV/mil (displacement).
Actual Sensitivity Enter the sensitivity value of the transducer that is
included with the transducer’s calibration
documentation. Due to manufacturing variation, the
actual sensitivity may be different than the nominal
sensitivity. This value is +/- 15% of the Nominal
Sensitivity value, see the above table.
Note: The nominal sensitivity is used if you
leave this field blank.
DC High Limit Enter the maximum expected DC bias voltage from the
transducer. Enter a value between -24...24 volts. See
Approximate Expected Bias Voltage (V DC)
Table on page 65
.
Note: A voltage reading outside this range
constitutes a transducer fault, which is
indicated by the Channel LED flashing red and
the Ch0Fault or Ch1Fault input tag, depending
on the channel.
For information about the LEDs, see page 87 .
For information about the input tags, see
page 91 .
DC Low Limit Enter the minimum, or most negative, expected DC
voltage from the transducer.
In this field Values are Comments
Quantity of
Measure
Nominal
Sensitivity
Acceleration 10.0 mV/ g
25.0 mV/ g
50.0 mV/ g
100.0 mV/ g
500.0 mV/ g
1000.0 mV/ g
10000.0 mV/ g
Velocity 100.0 mV/ in/s
150.0 mV/ in/s
200.0 mV/ in/s
500.0 mV/ in/s
1000.0 mV/ in/s
4.0 mV/ mm/s
6.0 mV/ mm/s
8.0 mV/ mm/s
20.0 mV/ mm/s
40.0 mV/ mm/s
Displacement 100.0 mV/ mil
150.0 mV/ mil
200.0 mV/ mil
285.0 mV/ mil
3.94 mV/ µm
5.91 mV/ µm
7.87 mV/ µm
11.2 mV/ µm
Pressure 20.0 mV/ psi
50.0 mV/ psi
100.0 mV/ psi
0.29 mV/ mbar
0.73 mV/ mbar
1.45 mV/ mbar
Volts 1000.0 mV/V