Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 127)

Publication ICM-UM002F-EN-E - March 2013 127
CIP Objects Appendix B
Instance Attributes
Services
(1)
Attributes can only be set while the device is in Program Mode. See the description of the Device Mode Object
for more information.
Table B.27 Band Measurement Object Instance Attributes
Attr ID
Access
Rule Name Data Type Description Semantics
3 Get Band Value REAL The measured band value. See Data Units
4 Get Status BOOL Indicates if a fault or
alarm has occurred. 0 = Operating without alarms or
faults
1 = Alarm or fault condition
exists, the
Band Value
attribute may not represent the
actual field value.
5 Get Data Units ENGUNIT The units context of the
Band Value attribute.
This attribute is read only. It is
set according to the
Output
Data Units attribute of the
associated Channel Object
instance. See
page 128 .
6 Get/Set Measurement USINT The measurement (or
calculation) performed to
produce the
Band Value.
0 = RSS
1 = Peak
7 Get/Set Minimum
Frequency REAL The minimum frequency
that is included in the
band measurement.
8 Get/Set Maximum
Frequency REAL The maximum frequency
that is included in the
band measurement. The Maximum Frequency must
be greater than or equal to
Minimum Frequency.
9 Get/Set Frequency Units USINT The units of
Minimum
and
Maximum
Frequency.
0 = Hz
1 = Orders
Table B.28 Band Measurement Object Services
Service
Code Class/Instance Usage Name Description
0E
h
Instance Get_Attribute_Single Returns a single attribute.
10
h
Instance Set_Attribute_Single
Sets a single attribute.
(1)