Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 130)

130 Publication ICM-UM002F-EN-E - March 2013
Appendix B CIP Objects
Services
(1)
Attributes can only be set while the device is in Program Mode. See the description of the Device Mode Object
for more information.
Device Mode Object
(Class ID 320
H
)
The Device Mode Object is used to control access to the configuration
parameters in the module. This object’s Device Mode attribute must be in
PROGRAM mode to allow the module’s configuration parameters to be Set
(see Services). Attempts to set the configuration parameters while the Device
Mode is in RUN mode will return an error. Note that the module collects
measurements while in RUN mode but not while it is in PROGRAM mode.
Class Attributes
The Device Mode Object provides no class attributes.
104 Get Very High HPF
Corner Frequency REAL The frequency, in Hz, of
the "Very high"
Low
Cutoff Frequency option
for attribute 5.
Hz
105 Get Channel Alarm
Status USINT Summary of the Alarms
configured for this
channel. 0 = Normal
1 = Alert (alarm)
2 = Danger (shutdown)
3 = Disarm
Table B.29 Channel Object Instance Attributes
Attr ID
Access
Rule Name Data Type Description Semantics
Table B.30 Channel Object Services
Service
Code Class/Instance Usage Name Description
0E
h
Instance Get_Attribute_Single Returns a single attribute.
10
h
Instance Set_Attribute_Single
Sets a single attribute.
(1)