Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 131)

Publication ICM-UM002F-EN-E - March 2013 131
CIP Objects Appendix B
Instance Attributes
Setting the Device Mode attribute to 1 (RUN) is equivalent to executing the
Start
service. Setting the Device Mode attribute to 2 (PROGRAM) is
equivalent to executing the Stop service.
Services
Table B.31 Device Mode Object Instance Attributes
Attr ID
Access
Rule Name Data Type Description Semantics
3 Get/Set Device Mode UINT The operating mode of the
module. 0 = Power Up
1 = RUN
2 = PROGRAM
199 Set Backdoor
Service USINT Setting this attribute is
equivalent to requesting
the specified service. Set to one of the following
values to perform the specified
service:
05
h
= Reset
09
h
= Delete
15
h
= Restore
16
h
= Save
Table B.32 Device Mode Object Services
Service
Code Class/Instance Usage Name Description
0E
h
Instance Get_Attribute_Single Return the value of a single
attribute.
10
h
Instance Set_Attribute_Single Set the value of a single
attribute.
07
h
Instance Stop Transitions from Run to the
Program state.
06
h
Instance Start Validate the device
configuration settings and
transition to the Run state if
OK.
05
h
Instance Reset Transition to the Power Up
state. Load the non-volatile
configuration and transition
to the Run state if saved
configuration restored.