Metrohm 730 Sample Changer - Manuel (Page 80)

4.2 The Keyboard
730 Sample Changer, Detailed Description 77
Key Normal State Editing
HOLD
LEARN Interrupt Process
• The <HOLD> key inter-
rupts the processing of a
method. However con-
nected peripheral instru-
ments (Titrinos, etc.) are
not halted. Only method
processing is interrupted.
• In the "HOLD" state a
method can be completely
halted with <STOP> or
continued with the next
command in line by
pressing <START>.
• After quitting an error
message during method
processing the changer
automatically goes into the
"HOLD" state.
Switch on LEARN mode
• The <LEARN> key serves
to start the Learn mode.
This mode is provided for
easier editing of process
sequences. It allows direct
acceptance of a parameter
value that has been set by
manual control.
• LEARN mode is available
for the following com-
mands:
LIFT, DOS, STIR, PUMP,
SCN, WAIT
• Further information about
the LEARN mode can be
found on page 50.