Metrohm 730 Sample Changer - Manuel (Page 10)

2.1 Setting up the Instrument
730 Sample Changer, Installation 7
2 Installation
2.1 Setting up the Instrument
Packaging
The 730 Sample Changer is supplied with the accessories in
separate special packages designed to ensure maximum protec-
tion. These contain shock-absorbing foam linings. As only these
special packages guarantee damage-free transport of the instru-
ment, it is essential you store them in a safe place.
Control
Immediately following delivery, check that the consignment is
complete and undamaged (compare with delivery note and acces-
sories list in the Instructions for Use, page 183). In case of dam-
age see "Warranty", page 178.
Setting up
The 730 Sample Changer is a rugged instrument and may be
used in rough environments such as laboratories and manufac-
turing plants. It must not be exposed to a corrosive atmosphere.
If the sample changer is operated in a rough environment, regular
maintenance is strongly recommended.
2.2 Power Supply
Follow these instructions to connect the 730 Sample Changer to
the power supply. Ensure that the instrument is never operated
with incorrect voltage ratings and/or with fuses of an incorrect rat-
ing, otherwise there is a fire hazard!
Setting the instrument supply voltage
Before switching on the Sample Changer for the first time, check
that the line voltage set on the instrument (see next page)
matches the local power supply voltage. If this is not the case,
change the voltage setting as follows: