Metrohm 730 Sample Changer - Manuel (Page 155)

4.10 Remote Control Commands
730 Sample Changer, Detailed Description
152
4.10.2.55 A ssembly.Dos $G, $S
A ssembly.Dos.Adress 1 ...12
A ssembly.Dos.Value ±0.01…999.999 ml, fill, release,
prepar., empty, eject, adjust, level
Control of dosing units.
.Address
Selection of dosing unit
.Value Volume or function
&Assembly.Dos;$G triggers this function.
4.10.2.56 A ssembly.Scan $G, $S
A ssembly.Scan.Adress Rm , RS
A ssembly.Scan.Pattern
With Rm (parallel/Remote): 8 x 1,0 or ∗ (bin)
ready1 , ready2, ready ∗ ,
end1, end2, endmeter
With RS (serial/RS232): 14 ASCII characters
Scanning the interfaces.
.Address
Selection of interface (Remote / RS232)
.Pattern Signal or character string
This function is not applicable for process control via RS232 in-
terface. See &Info.ActualInfo.Inputs and …Outputs (4.10.2.32 and
4.10.2.33) instead.
4.10.2.57 A ssembly.Ctrl $G
A ssembly.Ctrl.Adress Rm , RS
A ssembly.Ctrl.Pattern
With Rm (parallel/Remote): 14 x 1,0 or ∗ (bin),
START device1, START device2,
START device ∗ , START dos1, START dos2,
START dos ∗ , METER mode pH,
METER mode T, METER mode U,
METER mode I, METER mode C,
METER cal pH, METER cal C,
METER enter, INIT
With RS (serial/RS232): 14 ASCII characters
Signal or data transmission via interfaces.
.Address
Interface selection (Remote/RS232)
.Pattern Signal or character string
With the Remote interface predefined bit patterns may be applied
using the short names listed above (see page 99).