If you cannot install the usb driver, S’il est impossible d’installer le pilote usb – Sony DCR-TRV22E Manuel d'utilisation

Page 213

Advertising
background image

213

Viewing images with your computer Visualisation d’images à l’aide de votre ordinateur

(4) Follow the on-screen messages so that

the Add Hardware Wizard recognises
that the USB drivers have been installed.
The Add Hardware Wizard starts twice
because 2 different USB drivers are
installed. Be sure to allow the
installation to complete without
interrupting it.

You cannot install the USB driver if the
“Memory Stick” is not in your camcorder
Be sure to insert the “Memory Stick” into your
camcorder before installing the USB driver.

If you cannot install the USB
driver

The USB driver has been registered incorrectly
as the computer was connected to your
camcorder before installation of the USB driver
was complete. Follow the procedure below to
correctly install the USB driver.

Viewing pictures recorded on the
tape

Step 1: Uninstall the incorrect USB driver

1

Turn on the computer and allow
Windows to load.

2

Connect the AC Adaptor and set the
POWER switch to

1)

/

2)

.

3

Connect the USB port on the computer
to the (USB) jack on your camcorder
using the USB cable supplied.

1)

DCR-TRV12E/TRV14E

2)

DCR-TRV19E/TRV22E/TRV33E

Connecting your camcorder to a
computer using the USB cable
(For Windows users)

Raccordement de votre caméscope à
votre ordinateur à l’aide du câble USB
(pour les utilisateurs de Windows)

(4) Suivez les messages à l’écran pour que

l’assistant d’ajout de nouveau matériel
détecte les pilotes USB. L’assistant ajout
de nouveau matériel (Add Hardware
Wizard) démarre 2 fois parce que 2
pilotes USB différents ont été installés.
Laissez l’installation suivre son cours
sans l’interrompre.

Vous ne pouvez pas installer de pilote USB
si aucun « Memory Stick » n’est inséré dans
votre caméscope
Insérez un « Memory Stick » dans votre
caméscope avant d’installer le pilote USB.

S’il est impossible d’installer
le pilote USB

Le pilote USB n’a pas été enregistré
correctement, car votre caméscope a été
branché sur votre ordinateur avant la fin de
l’installation du pilote USB. Suivez la
procédure suivante pour installer correctement
le pilote USB.

Visionnage d’images enregistrées
sur une cassette

Etape 1 : Désinstallez le pilote USB mal
installé

1

Mettez l’ordinateur sous tension et
laissez Windows démarrer.

2

Branchez l’adaptateur secteur, puis
réglez le commutateur POWER sur

1)

/

2)

.

3

Raccordez la prise (USB) de votre
caméscope au port USB de votre
ordinateur à l’aide du câble USB fourni.

1)

DCR-TRV12E/TRV14E

2)

DCR-TRV19E/TRV22E/TRV33E

Advertising