Labconco Protecto Ech Filtered Fume Hoods 183 Series 8' - Manuel (Page 40)

Chapter 3: Getting Started
Product Service 1-800-522-7658 34
Original instructions
***If one or more of the parameters is missing then press
“X”
to go back and create
it again. If on the second attempt you do not see all components then recheck all
component connections or you must contact Labconco Product Service.***
If all components are seen then press
“Ok.”
The hood will now reboot.
Step 6 – Scan in Filters.
After rebooting, it will show:
Access granted
(Maintenance)
No Filters installed
>Hood Status
Administration menu
Maintenance menu
Arrow down to the
“Administration menu”
and press
“Ok”
to select it.
You should see:
Language
Date and Time
Filters
Alarms and Sensors
Users and Management
Network Parameters
Erase History
Ventilation
Arrow to
“Filters”
and press
“Ok”
to select it.
You should now see:
>Filter list
Total replacement
Partial Replacement
Arrow down to
“Total Replacement”
press
“Ok.”
Press
“Ok” three times until you see “Record new filter tags” 0/12.
***Note it is important that the tags are not mixed up. The primary RFID tags remain
on the primary filters and the secondary tags remain on the secondary filters.***
Now take off the RFID tags that are on your primary filters only.
Remove your Maintenance card.