Labconco Protecto Ech Filtered Fume Hoods 183 Series 8' - Manuel (Page 32)

Chapter 3: Getting Started
Product Service 1-800-522-7658 26
Original instructions
First put the rubber insulator on the cord set then attach the wires following the
sequence below depending on your model:
The sequence is: Black to Brown/Black
Green to Yellow/Green
White to Blue/White
Push each wire all the way into their slot and tighten the set screws.
Make sure that after you tighten them they are secure by gently tugging on each
wire. If they come out from the set screw, they need to be loosened and redone. If
not then they are secure.
Brown or Black
Yellow/Green
Blue or White
Black
Green
White