Labconco Protecto Ech Filtered Fume Hoods 183 Series 8' - Manuel (Page 33)

Chapter 3: Getting Started
Product Service 1-800-522-7658 27
Original instructions
Put the red rubber piece in place and close the cover to protect the wires. Now
plug in your Ethernet cable (if applicable).
Next using a small Phillips, re-install the screw that holds the cord set to the
control module.
The power cord should now be connected to the control panel module.
Step 14 – Make all connections from control panel to technology.
In order to connect the control module to the fans and lights, you must first locate
the following connections from the control module to the technology:
 Light supply wire from control module to light #1
 Fan supply wire from control module to fan #1
 Air tube from control module to the “T” on fan #1 (If necessary, use
extension tubing and plastic fitting from cardboard box on pallet)
 Temp sensor (already connected)
 Sash sensor (already connected)
NOTE: Please reference pictures from Steps 4, 6, 9 and 11.
You should now have those connections located next to the technology.
Now connect all those connections to the technology.
Step 15 – Plug the power cord in and reconfigure.
Now plug in the controller. You will see it say “Booting” as it comes on. If it
indicates hardware mismatch alarm 9a, follow the “Reconfigure process”
combined with the GFH settings sheet to finish the installation.
Have a maintenance card in the card reader and follow the “reconfigure process”
at Step #4 Delete Factory configuration. Also set the days on the filter to the
maximum of 730. You will also now need to locate the GFH settings sheet that is
in each command module for the settings to enter when it is called for during the
“reconfiguration process.”
If after a Reconfigure there is still a problem, check all of your connections to be
sure they are properly seated. Then unplug the controller to reboot it. If it still
gives an error after this, call Labconco Product Service.