Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 99)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 99
Operate the Module Chapter 3
Transition to Run Mode
To collect data and monitor measurement devices, the module must be in Run
mode. To transition the XM-124 module from Program mode to Run mode on a
DeviceNet network, set the Device Mode parameter to Run mode and click
Apply.
Refer to your DeviceNet documentation for specific instructions on editing EDS
device parameters.
Reset Switch The XM-124 module has an external reset switch on top of the module. The
Reset switch can be used to reset all latched relays in the Relay Expansion module
when it is attached to the XM-124 module.
TIP The Module Status indicator is solid green when the module is in Run
mode.
TIP You can also use the Start service to transition to Run mode.
IMPORTANT The Reset switch resets the relays only if the input is no longer in alarm or
the condition that caused the alarm is no longer present.
Reset switch