Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 77)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 77
Configure the XM-124 Standard Dynamic Measurement Module Chapter 2
casing. Positioning of probes is critical to be sure that valid shaft movement
cannot at any time damage the probes. Selection of probe type and range is
obviously important. The static gaps of the probes are automatically subtracted
from the measurement so that the system can measure small movements relative
to the total gaps.
When using this mode, the module uses straight targets, angled targets, or mixed
target types, as shown in
Figure 38 .
Figure 38 - Normal Mode
The XM-124 provides monitoring facilities only for axial (thrust) measurements.
Eccentricity Measurement Options
The Eccentricity options apply to the Eccentricity measurement mode and affect
the Eccentricity measurement.