Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 63)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 63
Configure the XM-124 Standard Dynamic Measurement Module Chapter 2
Configure the Channel Properties
Use the Channel tab to define the characteristics of the transducer and the signal
processing performed on the input signals. The XM-124 module has two input
channels.
1. From the Module Properties dialog box, click the Channel tab.
2. Configure the parameters as necessary.
Transducer
In this field Values are Comments
Channel Name Enter a descriptive name for the channel. Maximum 18 characters.
Power Choose the type of power supplied to the transducer:
• Off
• IEPE (externally supplied)
• -24V (externally supplied)
• +24V (externally supplied from the terminal base)
• Bias Current (externally supplied) See Connect the Transducer on page 34 for wiring
requirements.
See table below.