Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 60)

60 Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Chapter 2 Configure the XM-124 Standard Dynamic Measurement Module
Figure 35 - Application Help Dialog Box
For help on topics other than module configuration, consult the back cover of
this manual for contact information for Rockwell Automation Support and
Installation Assistance.
Module Selection and Connection
The XM Serial Configuration Utility welcome screen is shown below. The
software version used for the XM-124 module may vary from the figure, but the
release number must be at least 7.0.0.
Figure 36 - 1XM Serial Configuration Utility Main Dialog Box
If the computer is connected to an XM-124 module, this is indicated by a closed
‘connector’ icon, and the application allows only configuration of that specific
module. If no module is connected, as in the above figure, the tool may be used to
edit configuration files for any type of module.