Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 26)

26 Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Chapter 1 Install the XM-124 Standard Dynamic Measurement Module
5. Gently push the side connector into the side of the neighboring terminal
base to complete the backplane connection.
Mount to Panel or Wall
Installation on a wall or panel consists of the following:
• Laying out the drilling points on the wall or panel
• Drilling the pilot holes for the mounting screws
• Installing the terminal base units and securing them to the wall or panel
Use the following steps to install the terminal base on a wall or panel.
1. Lay out the required points on the wall/panel as shown in the drilling
dimension drawing below.
2. Drill the necessary holes for the #6 self-tapping mounting screws.
3. Secure the terminal base unit using two #6 self-tapping screws.
To install another terminal base unit, retract the side connector into the
base unit.
Make sure it is fully retracted.
40.10
[1.577] 35.51
[1.398] 23.50
[.925]
94.01
[3.701]
Side Connector