Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 27)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 27
Install the XM-124 Standard Dynamic Measurement Module Chapter 1
4. Position the terminal base unit up tight against the neighboring terminal
base.
Make sure the hook on the terminal base slides under the edge of the
terminal base unit.
5. Gently push the side connector into the side of the neighboring terminal
base to complete the backplane connection.
6. Secure the terminal base to the wall with two #6 self-tapping screws.
Wire the Terminal Base Unit Wiring to the module is made through the terminal base unit on which the
module mounts. The XM-124 module is compatible only with the XM-940
terminal base unit, catalog number 1440-TB-A.
Figure 9 - XM-940 Terminal Base Unit
Terminal Block Assignments
The terminal block assignments for the XM-124 standard dynamic measurement
module are described below.
ATTENTION: The terminal block assignments are different for different
XM modules.
Table 2 applies only to the XM-124 module.
Refer to the installation instructions for the specific XM module for its
terminal assignments.
XM-940 (catalog number 1440-TB-A)