Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 144)

144 Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Appendix B CIP Objects
Services
(1)
Attributes can only be set while the device is in Program mode. See the description of the Device Mode Object for more information.
11 Get/Set Alarm Identifier B EPATH Identifies the second alarm status
the relay monitors. See Parameter Object instances 31…35.
See Table 48 on page 128 .
12 Get/Set Logic USINT Indicates the number of
associated alarms that must have
a status value specified by Alarm
Level to activate the relay. 0 = Ignore Alarm Identifier B and
activate the relay based on the status of
Alarm Identifier A.
1 = Activate the relay if the status of either
Alarm Identifier A or B matches any of
the statuses specified by Alarm Level.
2 = Activate the relay if the status of both
Alarm Identifier A and B match any of
the statuses specified by Alarm Level.
14 Get Relay Installed BOOL Indicates whether an actual relay
is associated with this instance. 0 = Not installed
1 = Installed
15 Get/Set Idle Hold USINT Hold relay state during
reconfiguration. 0 = Relay is deactivated while module is in
Program mode.
1 = Relay retains last state while in
Program mode.
Table 66 - Relay Object Instance Attributes
Attr ID
Access Rule
Name Data Type Description Semantics
Table 67 - Relay Object Services
Service Code
Class/Instance Usage Name Description
05
h
Class/Instance Reset Resets latched relay.
0E
h
Class/Instance Get_Attribute_Single Returns a single attribute.
10
h
Class/Instance Set_Attribute_Single Sets a single attribute.
(1)