Lincoln Electric CLASSIC SVM194-A - Manuel (Page 54)

INSTALLATION A3.2 A3.2
CLASSIC® 300D & 300G
TECHNICAL SPECIFICATIONS - CLASSIC® 300D KUBOTA
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
4 Cylinder
4 Cycle 134.1 cu. in 12VDC battery Fuel: 15 gal.
Naturally Aspirated (2.2 ltrs) (Group 24, 650 57 L
Kubota Water-Cooled High Idle 1800 cold crank amps)
V2203M Diesel Engine Low Idle 1400 Bore x Stroke 1.4 KW Starter Oil: 8.0 Qts.
Cast Iron Cylinder, Full Load 1800 40 A. Alternator 7.6 L
Block/Crankcase 3.43” x 3.64” w/ built in reg. Coolant:
32.5HP @1800 RPM 9.5 Qts.
9.0 L
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
MODEL HEIGHT WIDTH DEPTH WEIGHT
K1643-5 CSA@ 1320 lbs.
With Out (599 kg)
Wire Feed Module
45.5 in. 24.00 in. 66.36 in.
K1643-6 CSA @ (1156 mm) (610 mm) (1686 mm) 1355 lbs.
With Wire Feed Module (615 kg)
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT* Duty DC CURRENT RANGE
VOLTS @ RATED AMPS CYCLE Fine Adjustments in each Range
40-350 Amps
220-Max.
300 Amp DC Welder 30V @ 250A 100% 160-240
All Copper Windings 32V @ 300A 60% 120-190
Pure DC Power Generator 99V DC Max. OCV @ 1800RPM 80-130
Min.-90
Auxiliary Power (1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 115V
13 Amps @ 230V
PHYSICAL DIMENSIONS
(2)
*
Based on a 10 min. period.
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2) Height to top of exhaust elbow.
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC