Lincoln Electric CLASSIC SVM194-A - Manuel (Page 42)

ACCESSORIES C2.2 C2.2
CLASSIC® 300D & 300G
OPTIONAL FEATURES (Field Installed)
GENERAL OPTIONS
Pipe Thawing with an arc welder can cause fire,
explosion, damage to electric wiring or to the arc
welder if done improperly. The use of an arc welder
for pipe thawing is not approved by the CSA, nor is
it recommended or supported by Lincoln Electric.
------------------------------------------------------------------------
Power Plug Kit K802D
A power plug kit for the auxiliary power receptacles is
available. (Provides a plug for each receptacle.)
Spark Arrestor Kit K903-1
Includes a heavy gage steel, approved spark arrestor,
clamp and adapter for mounting to the muffler exhaust
pipe.
TRAILER K953-1
Two-wheeled trailer with optional fender and light package.
For highway use, consult applicable federal, state, and local
laws regarding possible additional requirements. There is a
choice of 2 hitches, a fender & a light package.
Ball Hitch K958-1
Lunette Eye Hitch K958-2
Fender & Light Kit K959-1
Cable Rack K965-1
Service Indicator Kit K1858-1
Provides a GO / NO-GO visual indication of air clean-
er element useful service life. Filter service based on
restriction readings allows the longest life possible
from the filter and best engine protection.
STICK OPTIONS
ACCESSORY SET K704
Includes 35 feet (10 m) of electrode cable and 30 feet
(9 m) of work cable, headshield, work clamp and elec-
trode holder. Cable is rated at 500 amps, 60% duty
cycle.
Remote Control Kit K924-5
Contains remote control rheostat and 100 ft. (30.5 m)
cable for adjusting the OCV at the welding site.
TIG OPTIONS
TIG Module K930-2
Provides high frequency and shielding gas control for
AC and DC GTAW (TIG) welding applications. Its com-
pact case is designed for easy carrying, complete with
a handle. High frequency bypass is built in.
Additionally, the K936-3 control cable is required if
remote control is used. If remote control is not used the
K936-4 control cable is required.
PTA-26V TIG Torch K1783-9
Air cooled 200 amp torch equipped with valve for gas
flow control. 25Ft. length.
Magnum Parts Kit For PTA-26V TIG Torch KP509
Control Cable K936-4 (required for TIG Module)
Control cable for connecting the K930-2 TIG Module.
Arc Start Switch K814 (required for TIG Module)
Comes with a 25ft.(7.6m) cable.
Attaches to the TIG torch for convenient finger control.
Contactor Kit K938-1 (required for TIG Module)
Provide “Cold” tungsten Tip when welding with the TIG
Module.
Control Cable Extension K937-45
Allows the TIG Module to be operated at distances up
to 200 ft. from the power source.Available in 45 ft.
(13.7m).
Water Valve Kit K844-1
For use with a water-cooled TIG torch. Installs inside
TIG Module.
WARNING
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Section
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC
Return
to
Master
TOC