John Wood Atmospheric Gas (ENERGY STAR) - NEW - Manuel (Page 21)

21
ELECTRICAL CONNECTIONS/WIRING DIAGRAM
Electrical Connections
Before plugging in the water heater, always make sure:
• The Voltage and frequency correspond to that specified on the
water heater.
• The electrical outlet has the proper overload fuse or breaker
protection.
• Water heater to be located within 6 feet of 120VAC outlet.
• Unit is to connect to a 120VAC electrical supply outlet
(extension cord is not allowed).
• The water heater and the outlet are properly grounded.
• Installed in accordance with CSA C22.1-current edition
(Canadian Electrical Code) and all local/provincial codes.
Completely fill the tank with water and check all connections for
leaks. Open the nearest hot water faucet and let it run for three
(3) minutes to purge the water lines of air and sediment and to
ensure complete filling of the tank. The Electrical power may then
be turned on. Verify proper operation after servicing.
DAMPER
FLAME SENSOR\IGNITER
GAS CONTROL VALVE\THERMOSTAT
4 3 2 1 3 2 1
6 5 4
FV SENSOR
TEMPERATURE
CUT-OFF SWITCH
FLUE DAMPER
TRANSFORMER
1 2 3
4 5 6
BL
RD
YL YL
BN - 24VAC
V - 24VAC
BK - 120V
AC
WH - 120V
AC
GR
BK - 24VAC (HOT)
WH - 24VAC (NEUTRAL)
BL
RD
BL
RD
YL
YL
BK - 24V
AC (HOT)
WH - 24V
AC (NEUTRAL)
YL
- 24V
AC
YL
- 24V
AC
TRANSFORMER
YL
24 V
AC
GAS CONTROL VALVE/
THERMOSTAT
FV SENSOR
IGNITER/FLAME
SENSOR
BK - 120V
AC
W - 120V
AC
YL
24 V
AC
BK 24 V
AC (H)
WH 24 V
AC (N)
TEMPERATURE CUT-OFF
SWITCH
You must provide all wiring of the proper size outside of the water heater. You must obey local codes and electric
utility requirements when you install this wiring. This appliance must be electrically grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code ANSI/NFPA No 70 (current edition) and/or THE CSA C22.1 ELECTRICAL CODE.(LATEST EDITION)
Note: If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 105
° C wire or its equivalent.
YL
YL
ON/OFF SWITCH
END SWITCH
BN 24 V
AC
V 24 V
AC
FIGURE 23.
Disconnect power before
servicing.
Replacing all parts and
panels before operating.
Failure to do socan result in
death or electrical shock
WARNING
Electric Shock Hazard
Plug into a 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
WARNING
Electric Shock Hazard