Dell 5130cdn Color Laser Printer - Manuel (Page 70)

NOTE: If your computer provides a wireless adapter tool, change the wireless settings using this tool. Or you can
change the wireless settings using the tool provided with the operating system. See the instructions below.
For Windows XP and Windows Server 2003:
a. Select Network Connections from Control Panel.
b. Right-click Wireless Network Connection and select Properties.
c. Select Wireless Network tab.
d. Ensure the check box for Use Windows to configure my wireless network settings is checked.
e. Click Advanced.
f. Do either of the following:
When wireless ad-hoc mode is set to the printer:
Select Computer to Computer (ad hoc) networks only and close the Advanced dialog box.
When wireless infrastructure mode is set to the printer:
Select Access point (Infrastructure) networks only and close the Advanced dialog box.
g. Click Add to display Wireless network properties.
h. Enter the setting that you will send to the printer and click OK.
i. Click Move up to move the setting to the top of the list.
j. Click OK to close the Property dialog box.
NOTE: When your operating system is earlier than Windows 2000, select your settings according to the
instructions in the manual of the wireless settings tool provided by your wireless device manufacturer.
For Windows Vista:
a. Open Control Panel.
b. Select Network and Internet.
c. Select Network and Sharing Center.
d. Select Connect to a network.
e. Select the setting you send to the printer from the network items listed in Connect to a network.
f. Select Connect Anyway in the warning dialog box indicating you are entering an unsecured area.
g. Click Close in the dialog box after confirming the connection is a success.
For Windows Server 2008:
a. Open Control Panel.
b. Select Network and Sharing Center.
c. Select Connect to a network.
d. Select the setting you send to the printer from the network items listed in Connect to a network.
e. Select Connect Anyway in the warning dialog box indicating you are entering an unsecured area.
f. Click Close in the dialog box after confirming the connection is a success.
For Windows Server 2008 R2 and Windows 7:
a. Open Control Panel.