Dell 5130cdn Color Laser Printer - Manuel (Page 126)

Purpose:
To specify whether to enable or disable printing ports and management protocol features.
Values:
Ethernet* 1
Ethernet
Settings
Auto
Detects Ethernet transmission rate and the duplex settings
automatically.
10Base-T
Half-Duplex
Selects 10Base-T Half-Duplex as the default value.
10Base-T
Full-Duplex
Selects 10Base-T Full-Duplex as the default value.
100Base-TX Half-
Duplex
Selects 100Base-TX Half-Duplex as the default value.
100Base-TX Full-
Duplex
Selects 100Base-TX Full-Duplex as the default value.
1000Base-T Full-
Duplex
Selects 1000Base-T Full-Duplex as the default value.
Current Ethernet Settings Displays the current settings of Ethernet.
MAC
Address
Displays the printer's MAC address.
Port
Status
LPD Select the check box to enable LPD.
Port9100 Select the check box to enable Port9100.
IPP Select the check box to enable the IPP port.
WSD Select the check box to enable the WSD port.
FTP Select the check box to enable FTP.
NetWare Select the check box to enable the NetWare port. You can also configure the transport protocol
to be used. TCP/IP can be selected simultaneously as the transport protocol.
Bonjour
(mDNS)
Select the check box to enable the Bonjour(mDNS) feature.
E-Mail
Alert
Select the check box to enable the E-Mail Alert feature.
Telnet Select the check box to enable Telnet.
SNMP
Select the check box to enable the SNMP (Simple Network Management Protocol).
You can also configure the transport protocol to be used. UDP and IPX can be selected
simultaneously as the transport protocol.
*
1 This item is available only when connecting the printer with a wired network.
NOTE: The settings in the Port Settings page will be valid only when the printer is rebooted. When you change or
configure the settings, click the Apply New settings button to apply new settings.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values:
IP Mode Specifies the IP mode.
Host Name Specifies the host name.
IPv4
IP Address Mode Selects the IP address mode.
Manual IP
Address
Sets the IP address.
Manual Subnet
Sets the subnet mask.