Dell 5130cdn Color Laser Printer - Manuel (Page 176)

Manual
Setup
Ad-hoc
Select to configure the wireless setting without the access point such as a wireless router.
No
Security
Select to configure the wireless setting without specifying the security method
from WEP.
WEP Key
Entry
(64Bit)
Specify the WEP 64bit Key to use through the wireless network. Up to 10
hexadecimal characters can be entered.
Transmit
Key
Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key
3, and WEP Key 4.
WEP Key
Entry
(128Bit)
Specify the WEP 128bit Key to use through the wireless network. Up to 26
hexadecimal characters can be entered.
Transmit
Key
Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key
3, and WEP Key 4.
WPS
Push
Button
Control
PBC Start
Cancel* Disables the security method of WPS-PBC.
Start Configures the wireless setting with the security method of WPS-PBC.
PIN Code
Start
Configu-
ration
Configures the wireless setting using the PIN code assigned automatically by the
printer.
Print PIN
Code
Prints PIN Code. Confirm it when entering PIN assigned to the printer into your
computer.
NOTE: This item is available only when connecting the printer with a wireless network.
Reset Wireless
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network settings
are reset to their default values.
NOTE: This item is available only when connecting the printer with a wireless network.
TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on again.
Values:
IP
Mode
Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
IPv4
Get IP
Address
AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the keys on the operator
panel.
Subnet Mask Sets the subnet mask.
Gateway Address Sets the gateway address.
IPsec* 1 Disables IPsec.
*
1
Only displayed when an optional network protocol adapter is installed and IPsec is enabled.