Dell 5130cdn Color Laser Printer - Manuel (Page 179)

Purpose:
To specify the ECP communication mode of the parallel interface. The change becomes effective after the printer is turned
off and then on again.
Values:
Disable ECP communication mode is disabled.
Enable* ECP communication mode is enabled.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for parallel interface. You can configure the Adobe Protocol settings for
parallel port. The change becomes effective after the printer is turned off and then on again.
Values:
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary Used when no special processing is required for data.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
USB Port
Purpose:
To enable or disable the USB interface. The change becomes effective after the printer is turned off and then on again.
Values:
Disable The USB interface is disabled.
Enable* The USB interface is enabled.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for USB interface. You can configure the Adobe Protocol settings for USB.
The change becomes effective after the printer is turned off and then on again.
Values:
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.