Dell 5130cdn Color Laser Printer - Manuel (Page 285)

This option is available only for color printing and when entry data is RGB data.
-Cb=cyan-low:cyan-middle:cyan-high:magenta-low:magenta-middle:magenta-high:yellow-low:yellow -
middle:yellow high:black -low:black-middle:black-high
Specifies adjustment value for color balance of each color/density.
Available adjustment values are as follows:
+3
Dark 3
+2
Dark 2
+1
Dark 1
0
Normal
-1
Light 1
-2
Light 2
-3
Light 3
-Cb
Option value must be specified in the following order:
Cyan low density, Cyan medium density, Cyan high density, Magenta low density, Magenta medium density,
Magenta high density, Yellow low density, Yellow medium density, Yellow high density, Black low density,
Black medium density, Black high density
If no value is specified, it is treated as "0"(Normal).
For example, if you want to specify "Light 2" for Cyan medium density, "Dark 3" for Yellow high density, and
"Dark 2" for Black low density, it can be specified using either of the following:
-Cb=0:-2:0:0:0:0:0:0:+3:+2:0:0
-Cb=:-2:::::::+3:+2::
-Sl=mode
Specifies staple settings.
Available staple option values are as follows:
0
Off
1
On
This option is available only when the optional output expander is installed.
-Os=mode
Specifies offset settings.
Available offset option values are as follows:
0
Auto
1
Offset per Set (Offsets each copy before printing the next copy.)
2
Offset per Job (Offsets each copy per paper job you specify.)