Sony DSR-45/45P Manuel d'utilisation

Page 70

Advertising
background image

Duplication (generating a work tape with the same time code)

Chapter 5 Duplication and Audio Dubbing

70

(GB)

Chapter 5

Duplication and Audio Dubbing

3

While holding the DUP button down, press the
PLAY button on this unit.

This unit and the player will automatically rewind
the tape to the beginning. This unit enters the
duplicate-standby mode. The player enters the
playback pause mode. Then the DUP and PLAY
indicators on this unit light and the duplication
starts.

If you press the PAUSE and PLAY buttons
while holding the DUP button down in step 3

This unit and the player will automatically rewind the
tape to the beginning. This unit enters the duplicate-
standby mode. The player enters the playback pause
mode. This unit does not start duplication until you
press the PAUSE button.

To stop duplication

Press the STOP button on this unit.

Notes

• You cannot pause during a duplicate process.
• Before you start duplication, make sure that the

player has finished loading the cassette.

• The duplication starts after the i.LINK

communication is established so that the first part of
the source tape is dropped on the copied tape.

• Set auto repeat to OFF when the player has an auto

repeat function and set auto rewind to ON when the
player has an auto rewind function.

• If the player has a still timer function, set the still

timer to the longest time possible to ensure enough
time for rewinding the tape to the beginning.

• If you have selected AUTOq

duplicate mode,

the cassette memory will be duplicated after the tape
has been duplicated. While the cassette memory is
being duplicated, an indicator showing the progress
of the duplication appears on the LCD monitor and
on the MONITOR VIDEO output. Duplicating the
cassette memory takes up to a few minutes depending
on the amount of data.
In the following cases, duplication of the cassette
memory will be cancelled and the duplicate operation
will be completed without duplicating the cassette
memory.
If, while the cassette memory is being duplicated;
– you press the STOP button.
– you turn off the power of this unit or of the player.
– you eject the cassette.
– you disconnect the DV cable.

If the duplication of the cassette memory stops for
some reason, the cassette memory on the duplicated
tape will be completely erased.

• When both the recorder and the player are DSR-45/

45Ps, set the REMOTE/LOCAL switch of the player
as well as that of the recorder to LOCAL.

• If you operate the player while duplicating and the

PLAYER UNCONTROLLABLE warning message
appears and duplication is stopped, press the STOP
button on this unit, then repeat the procedure from
step

3

.

• Normally, the player and recorder rewind their tapes

automatically after duplication. However, depending
on the specifications, some players do not.

MANUAL

q

duplicate mode

1

Connect this unit and the player using an i.LINK
cable (DV cable, not supplied). After turning on
power of this unit and the player, set the INPUT
SELECT selector on this unit to DV.

2

Locate the points where you want to start playback
and recording.

3

Press the STOP button on this unit to stop the tape
transport operation.

4

While holding the DUP button down, press the
PLAY button on this unit.

This unit enters the duplicate-standby mode. The
player enters the playback pause mode. Then the
DUP and PLAY indicators on this unit light and
duplication starts.

To adjust the point where duplication starts

In step

4

, while holding the DUP button down, press the

PAUSE button and the PLAY button. This unit will not
start duplication until you press the PAUSE button again.
After confirming that the PLAYER display has changed
to READY (flashing) on the LCD monitor, adjust the
duplication start point using the player, then press the
PAUSE button on this unit to start duplication.

To stop duplication

Press the STOP button on this unit.

Advertising