Location and function of parts – Sony DSR-45/45P Manuel d'utilisation

Page 14

Advertising
background image

14

(GB)

Chapter 1

Overview

Location and Function of Parts

Chapter 1 Overview

– Audio recording level adjustment mode (AUTO/

MANU)

– Audio mode (32 kHz/48 kHz)
– Audio limiter
– Color bars (Cannot be displayed)

• If you change this selector, the screen may

momentarily become bright or noise may appear.
This noise will be recorded.

• Do not change this selector setting during recording.

Otherwise, the recorded image will be distorted or the
signal output from the DV jack will be interrupted.
Also, the unit may mistakenly recognize that a
copyright protected signal has been input.

qa

EJECT (OPEN/CLOSE) (open/close the cassette

compartment) button
Press this button to open or close the cassette
compartment. If you press this button while a cassette
is inside the unit, the compartment opens and the
cassette is ejected.
After removing the cassette, press this button again to
close the compartment.

1

Monitor display section

1

LCD (Liquid Crystal Display) monitor

Displays the playback or EE

1)

pictures. Also,

superimposed time data, status information, menu,
audio levels meters, etc. are displayed.

Notes

• The data items superimposed on the LCD monitor are

the same as items superimposed on a monitor
connected to the MONITOR VIDEO jack.
You cannot make two monitors display different data
items individually.

• The backlight used in the built-in LCD monitor

deteriorates with prolonged use. If the brightness of
the LCD monitor cannot be adjusted, consult your
Sony dealer.

For details on the maintenance of the LCD monitor, see
page 99 (GB).

2

CHARACTER DISPLAY (LCD) (data items

superimposed on the LCD monitor) selector
Use to superimpose data items on the LCD monitor.

OFF: No data items are superimposed except the

tape label, title, data codes (camera data, and date/
time recorded by a camera).

ON: Data items are superimposed.
ON (BLACK BACK): Data items are displayed on a

black background.

1

LCD monitor

2

CHARACTER DISPLAY
(LCD) selector

3

DISPLAY SELECT selector

4

EXEC or FINE (AUDIO)
button

5

J

/

j

buttons

.........................................................................................................................................................................................................

1) “EE” stands for “Electric to Electric.” In EE mode, the

video and audio signals that are input to the VCR’s
recording circuitry do not pass through any magnetic
conversion circuits but instead are output via electric

circuits only. This mode is used to check the input
signals and adjust input levels. The pictures output in EE
mode are referred to as EE pictures.

Advertising