Connections for digital non-linear editing – Sony DSR-45/45P Manuel d'utilisation

Page 48

Advertising
background image

Chapter 3 Using the Unit as a Player in an Editing System

48

(GB)

Chapter 3

Using the Unit as a Player in an Editing System

Connections for Digital Non-linear Editing

The unit can be connected to an editing controller via
DV jacks to configure a digital non-linear editing
system.
The following figure shows a connection diagram for
non-linear editing system in which this unit serves.

For connection of the editing controller and its peripheral
devices, refer to the instruction manual of the editing
controller and that of the editing software you use.
Edit functions are specified by the editing software. For
details on the editing methods used, refer to the instruction
manual of the editing software.

MONITOR
AUDIO

DV

1

1

2

MONITOR

VIDEO

DSR-45/45P

Video input

Audio input

Video monitor

Editing controller

1

Phono jack cable (not supplied)

DV jack

If the editing software used has the capability to
output the time code as well as the video or audio
signals from the digital non-linear editing controller
to this unit, and you intend to record the time code,
set DV IN TC on the TC/UB SET menu of this unit
to EXTERNAL.

For details on the TC/UB SET menu, see “TC/UB
SET menu” on page 78 (GB).

2

i.LINK cable (DV cable) (not supplied)

Note

If the unit is connected to a device equipped with a 6-
pin DV jack, when you intend to disconnect or
reconnect the DV cable, turn off the device and pull
out the plug of its power cord from the AC outlet
beforehand. If you connect or disconnect the DV cable
while the device is connected to the AC outlet, high-
voltage current (8 to 40 V) is output from the DV jack
of the device to this unit, which may cause a
malfunction.

Advertising