Location and function of parts – Sony DSR-45/45P Manuel d'utilisation
Location and Function of Parts
Chapter 1 Overview
INDEX WRITE button
Press this button during recording to mark an index.
For details on an index, see “Marking an index” on page 44
DATA CODE button
Press this button to display the data codes (recording
date/time, camera data).
For details on data codes, see “Displaying information
(data codes) recorded on a tape” on page 36 (GB).
1 (on/standby) switch
• The command mode of the supplied Remote
commander is set to VTR4. You cannot change this
• Set COMMANDER on the OTHERS menu to
WIRELESS to enable the Remote Commander to
control the unit.
• In addition to the Remote Commander supplied with
the unit, the unit accepts signals from any Sony
Remote Commander whose command mode is set to
VTR4. If you want to disable the control from any
Remote Commander, set COMMANDER on the
OTHERS menu to CONTROL S.
• If the REMOTE/LOCAL switch is set to REMOTE,
the control of the Remote Commander is restricted by
the setting of LOCAL ENBL on the REMOTE menu.
Push and slide the lid to open.
Be sure to install the
battery from the
Install two size AA (R6) batteries (supplied) with
the correct polarity.
Replace the lid.
Notes on batteries
• Make sure that the battery orientation is correct when
• Do not mix an old battery with a new one, or mix
different types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If the batteries have leaked,
remove them, wipe the battery compartment dry and
replace the batteries with new ones.
To remove the batteries
Remove the lid as step
and take out the batteries.