GE Industrial Solutions Entellisys Low Voltage Switchgear - Manuel (Page 46)

46
WARNING: Unless the proper precautions are taken,
the installation of a shutter unit presents the hazard
of electrical shock and burn. Do not install the shutter
unit unless the equipment has been de-energized.
Failure to do this can result in serious injury.
ADVERTISSEMENT: A moins que les précautions
nécessaires ne soient prises, l’installation d’une unité
à volet présente des risques de choc électrique ou de
brûlure. Il ne faut pas installer l’unité à volet à moins
que l’équipement ait été désamorcé. L’omission de ce
faire peut résulter en blessures sérieuses.
To install these shutter units, proceed as follows:
1. Carefully maneuver the shutter frame into the
compartment, first lifting it over the racking cams
on each side wall of the cassette. Make sure the
shutter fits over the shutter actuator at the
bottom of the cassette.
2. Position the shutter frame against the stab tip
braces and align the holes with the stand-off on
the braces.
3. After the holes are aligned with the threaded
stand offs, attach the shutter in 4 corner locations
using the bolts supplied.
4. Check the operation of the moveable shutters by
actuating the shutter lever on the bottom of the
cassette.