Engine bottom, as shown in figure d.1 . examine, Figure d.1, Maintenance – Lincoln Electric COMMANDER 400 SVM133-B Manuel d'utilisation
Page 39
CHANGE THE OIL FILTER: Change the oil filter the
first time between 25 and 50 hours of operation. Then,
under normal operating conditions, change the oil filter
after every 250 hours of operation. If the engine is
operated under heavy load or in high ambient temper-
atures, change the oil filter more frequently. See Table
D.1 for recommended maintenance intervals. See
Table D.2 for replacement oil filters.
Change the oil filter as follows:
1.
Remove the oil drain plug. Drain the oil from the
engine and allow the oil filter to drain. See Figure
D.1.
2.
Remove the old filter (spin it off) and discard it (2).
Wipe off the filter mounting surface and adapter.
See Figure D.1.
3.
Fill the new filter with fresh engine oil. Apply a thin
coat of new oil to the rubber gasket on the new oil
filter.
4.
Spin the new filter onto the mounting adapter finger
tight until the gasket is evenly seated. Then turn it
down another 1/2 turn. Do not over tighten the new
filter.
5.
Refill the engine with the proper amount and type
of oil as described in the Change the Oil section,
above. Start the engine and check for leaks
around the filter element. Correct any leaks (usu-
ally by retightening the filter, but only enough to
stop leaks) before placing the Commander 400
back in service.
6.
If there are no leaks, stop the engine and recheck
the oil level. If necessary, add oil to bring the level
up to the “MAX” mark, but do not overfill. See
Figure D.1.
FUEL: At the end of each day's use, refill the fuel tank
to minimize moisture condensation and dirt contamina-
tion in the fuel line. Do not overfill; leave room for the
fuel to expand.
Refer to your engine operation manual for recom-
mended grade of fuel.
MAINTENANCE
D-3
D-3
COMMANDER 400
MAX
MIN
OIL FILL CAP
DRAIN PLUG
DIPSTICK
OIL FILTER
FIGURE D.1 – OIL DRAIN AND REFILL