Troubleshooting & repair, Warning scr removal and replacement – Lincoln Electric COMMANDER 400 SVM133-B Manuel d'utilisation
Page 149
TROUBLESHOOTING & REPAIR
F-95
F-95
COMMANDER 400
WARNING
SCR REMOVAL AND REPLACEMENT
Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician or
machine operator and will invalidate your factory warranty. For your safety and to avoid elec-
trical shock, please observe all safety notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical troubleshoot-
ing assistance before you proceed. Call 1-800-833-9353 (WELD).
DESCRIPTION
The following procedure will aid the technician in removing the SCRs from the output rectifier
heat sink for maintenance or replacement.
MATERIALS NEEDED
NO.000 Fine Steel Wool
Penetrox A-13 (Lincoln E2529) or Penetrox A
7/16” Open end wrench
Allen head type wrenches
This procedure takes approximately 50 minutes to perform.