Garland MASTER SERIES HEAVY DUTY GAS RANGES AND CHAR BROILERS, ALL M/MS/MST SERIES MODELS - Manuel (Page 9)

Part # 1382680 Rev 3 (05/10/11) Page 9
INSTALLATION Continued
Installation
A
B
1. Install end rail support bracket.
A. Install end rail support bracket between manifold
bracket and top flange.
B. Align back holes on bracket with holes in the top of
the burner box side.
A
2. Install spacers between manifold bracket and top flange
before connecting center rail support bracket across
ranges. Be sure holes line up.
A. Spacer fits between flange and manifold bracket.
A
3. Align rail support bracket with holes (A) on top of 2
adjacent ranges and insert 2 screws and nuts to fasten.
Align studs with
holes in bracket
and range top.
Ensure nuts are
on studs prior to
being assembled
onto the range
Align holes in bracket
with hole in range
top. Assemble nuts
onto studs
4. End rail support bracket should align as per step 1. Studs
at each end of rail align with holes in end rail support
brackets. Assemble 1 nut onto stud before and after rail
assembly.
Note: End enclosure bracket should be installed at this point
between rail and end bracket if required. See final assembly
option step 7 .