Garland MASTER SERIES HEAVY DUTY GAS RANGES AND CHAR BROILERS, ALL M/MS/MST SERIES MODELS - Manuel (Page 4)

Part # 1382680 Rev 3 (05/10/11) Page 4
SPECIFICATIONS
MODEL NUMBER
GAS TYPE NATURAL GAS TYPE-PROPANE
INPUT (BTU/H) INPUT (BTU/H)
(M,MS)(12,43) Open Burner 24,000 20,000
MST43 Open Burner 24,000 20,000
M(M43-1,2,3),12S-6 Hot top burner 22,000 22,000
M43 FTR Front Open Burner 18,000 16,000
Rear French top 15,000 16,000
(M, MS)(4,42,44,54) Open Burner 35,000 35,000
MST(42,44,54) Open burner 35,000 35,000
(M,MS)(45,54,5) Spectro Heat Burner 15,000 11,000
MST45 Spctro Heat Burner
Total of 3 burners
40,000
Total of 3 burners
40,000
M(42-6,46,6) Even Heat Hot Top Burner. 30,000 30,000
MST(42-6,46,6) Even Heat Hot Top Burner 27,000 27,000
(M,MS)47 Griddle burner 33,000 33,000
MST 47 Griddle Burner 30,000 30,000
M48 Griddle Burner 33,000 33,000
(M,MS,MST) Oven Burner 40,000 35,000
(M,MS,MST)(17,24,34) Char-Broiler 15,000 15,000
(M1R) Single deck oven section 40,000 40,000
(M2R) Double stacked ovens 80,000 80,000
Natural Gas Operating Pressure=6.0” Water Column, measured at manifold tap.
Propane Gas Operating Pressure=10.0” Water Column, measured at manifold tap.
Clearance from Combustible Construction
Models (M,MST)5(S,T) & (M,MST)45(R,RC,S,T) must be
installed with no less than six inch (6”) clearance from
combustible construction at sides and rear .
Models (M,MS,MST)42(R,RC,S,T), (M,MS,MST)
44(R,RC,S,T), (M,MS,MST)54(R,RC,S,T), (M,MS,
MST)4(S,T), (M,MST)46(R,RC,S,T), (M,MST)47
(R,RC,S,T), M47-23(R,RCS,T), M47-45(R,RC,S,T), M48(R,RCS,T),
M48-23(R,RC,S,T), M48-45(R,RC,S,T) (M,MST)(6,7,8)(S,T) must
be installed with no less than fourteen inches (14”) on the
side, and six inch (6”) rear clearance from combustible
construction .
Models (M,MS,MST)43(R,RC,S,T) must be installed with no less
than eleven inch (11”) side and six inch (6”) rear clearance
from combustible construction .
Clearance from Non-Combustible
Construction
Models (M,MS,MST)(17,24,34)B(E) are for INSTALLATION IN
NON-COMBUSTIBLE LOCATIONS ONLY with zero (0”) sides
and rear clearance . Models with suffix “RC” must be installed
with zero inches (0”) side and no less than one inch (1”) rear
clearance from non-combustible construction. All other
models may be installed with zero inches (0”) sides and rear
clearance from non-combustible construction.