Garland MASTER SERIES HEAVY DUTY GAS RANGES AND CHAR BROILERS, ALL M/MS/MST SERIES MODELS - Manuel (Page 12)

Part # 1382680 Rev 3 (05/10/11) Page 12
OPERATION
Open Top Burners (M/MS Models)
Lighting
1. Remove top grates and ring grates.
2. Check flash tubes to see they are properly positioned on
burner charge ports.
3. Light pilots.
4. Replace top grates and ring grates.
5. Turn valve completely on by rotating the knob counter-
clockwise 1/4 turn. Burner flame should be 1/2” stable
blue flame and should impinge on the underside of pot
placed on ring grate.
Shut Down
1. Turn all valves to the “Off” position by rotating the knob
clockwise 1/4 turn.
2. If the unit is to be shut down for an extended period of
time, close the inline gas valve.
Open Top Burners (MST Models)
Lighting
1. Push in the gas valve and turn it anti-clockwise to the
ignition position.
2. Holding the valve fully in, light pilot burner with a match
or taper.
3. When the pilot is lit, continue to hold the valve fully in for
20 seconds, then release it. If the pilot goes out, wait for (5)
minutes, then repeat from step 1.
4. When pilot is established, push the valve in again and
turn it anti-clockwise to the desired flame setting.
5. To shut the burner off, turn the dial to the “O” position
and the safety device will disengage within (60) seconds.
Hot Top Sections And Spectro-Top Sections
(M Models)
Lighting
1. Raise or remove hot top sections. Every burner has one
pilot located at the front right side of the burner.
2. Light pilots. The pilot burner should be adjusted to
provide for rapid ignition on the burner.
3. Turn burner valve on by rotating the knob counter-
clockwise 1/4 turn. A sharp blue flame should be
approximately 1/4” high.
4. Replace hot top sections.
Shut Down
1. Turn all valves to the “OFF” position by rotating the knob
clockwise 1/4 turn.
2. If the unit is to be shut down for an extended period of
time, close the inline gas valve.
Hot Top Sections And Spectro-Top Sections
(MS/MST Models)
Lighting
1. Push in the valve and turn it anti-clockwise to the ignition
position.
2. Holding the valve fully in, light pilot burner with a match
or taper.
3. When the pilot is lit, continue to hold the valve fully in for
20 seconds, then release it. If the pilot goes out, wait for (5)
minutes, then repeat from step 1.
4. When pilot is established, push the valve in again and
turn it anti-clockwise to the desired flame setting.
5. To shut the burner off, turn the dial to the “O” position
and the safety device will disengage within (60) seconds.
Thermostatically Controlled Griddles
(M Models)
Lighting
1. Raise griddle at front and block.
2. Light Pilots located at the front right side of each burner.
3. Sensing bulbs must be fully inserted into their individual
holders which are located on the underside of the
griddle.
4. Set thermostat to maximum, one at a time. Burner
should have 5/16” stable blue flame. DO NOT ALLOW
THE GRIDDLE TO HEAT LONGER THAN 1 MINUTE! WHEN
READY TO USE THE GRIDDLE, IT MUST BE SEASONED
BEFORE ACTUAL USE, SEE “SEASONING INSTRUCTION” IN
THE MAINTENANCE SECTION.