Pioneer PDR-W839 - Manuel (Page 80)

80
En
9 Additional Information
Messages relating to recording
Message Cause Remedy Page
Can't REC The input signal is digital-copy
protected with SCMS. Record the source through the analog
inputs. p.65-70
D.IN UNLOCK The digital source was interrupted. Check that the digital input cable is
connected properly and that the power of
the source player is on. p.11
The source is not audio, or is an
incompatible format (e.g. a
CD–ROM). Check that the source is a regular music
source.
Can't SYNC The digital source is not recognized as
CD, MD, DVD, DAT, or DCC. If recording from a source other than CD,
MD, DVD, DAT or DCC, try using the
manual digital recording mode. p.70
CHECK
INPUT ? The source player was already playing
when the
SYNCHRO button was
pressed.
Stop the source player. After a short time,
SYNC–1 or SYNC–ALL is displayed,
and the recorder goes into synchro–record-
pause mode. p.67
REPAIR The recorder was switched
off/unplugged after recording without
ejecting the disc. The recorder could
not write essential recording
information onto the disc. While REPAIR is displayed, the recorder
automatically examines the recorded area
of the disc and updates the track numbers
and recording time data. This process takes
about 40 minutes for a fully recorded disc.
Finalization or further recording is possible
once the
REPAIR message disappears.
REC FULL No more recording is possible because
the available recording time of the disc
has been used up, or 99 tracks have
already been recorded on the disc. Use another disc, or erase the
CD–RW disc.
Pro DISC The loaded disc is a CD–R or CD–RW
disc for professional use without the
Consumer Use designation. Load a CD–R or CD–RW disc that is
designated as being for consumer use. p.8