MaxPower Corp Gamatronic Power+ M50 - Manuel (Page 67)

Gamatronic Electronic Industries Ltd.
POWER+ 3x208 V, User Guide, Release 2.3 51
d. When the Internet Protocol (TCP/ITP Properties screen appears, click the Use
the following IP address button and enter IP address and Subnet mask in
the appropriate fields. Leave Default gateway blank. Make sure that the first
three groups of numbers in the IP address (192.212.118 in the above example)
are the same as those of the domain in which the UPS is installed, and that the
last number (31 in the above example) is different (it can be any number from 0
to 255, other than the one already assigned to the UPS).
e. Click OK twice to complete the network connection.
3. Open your browser on the laptop computer and enter the IP address of the System
Controller in the browser’s address field to verify that you can reach the Web server
on the System Controller. The system displays the main GMaCi screen, similar to the
one shown below.
Figure 62: Main Screen of built-in web server
5.10.5 Test Wing Option
If Wing has been installed in the UPS, this test is designed to check that it is working properly
by sending an SMS message through the Web interface of Wing to a specified phone number.