MaxPower Corp Gamatronic Power+ M50 - Manuel (Page 158)

Gamatronic Electronic Industries Ltd.
142 POWER+ 3x208 V, User Guide, Release 2.3
9.3.5 “Control” main menu option
The “Control” main menu option enables the user to initiate any of a number of UPS processes.
The commands available are described in Table 15 below .
Figure 298: The "Control" main menu option screen
Table 15: Commands available on the “Control” screen
M ENU OPTION D ESCRIPTION
Load on bypass Transfers the load to the bypass voltage.
Load on inverter Transfers the load to the inverter.
Start battery test
Initiates a battery test. Note: it is recommended that a battery test not be
initiated when the when the UPS is operating near 100 % capacity and
at the same time the battery is known to be not fully charged or not
connected or otherwise faulty.
Abort battery test Stop a battery test immediately.
LED test
The UPS beeps briefly and all of the LEDs on the control panel light up,
to reveal any faulty LEDs.
Shutdown
Shuts down the Power+. Power will continue to be available to the loads
from the bypass voltage.
Startup Starts up the Power+ when it is in an “OFF” condition.
Restart
When the Power+ is “ON”, this command initiates a shutdown of the
Power+ followed by a startup.
At the bottom of the “Control” screen are two links: