Rockwell Automation 1756-SPESMNRMXT GuardLogix Controllers User Manual - Manuel (Page 65)

Rockwell Automation Publication 1756-UM020I-EN-P - August 2012 65
Communicate over Networks Chapter 4
Figure 15 - ControlNet Communication Example
(1) The 1734-ACN adapter does not support POINT Guard Safety I/O modules.
ControlNet Connections for Distributed I/O
To communicate with distributed I/O modules over a ControlNet network, add
a ControlNet bridge, a ControlNet adapter, and I/O modules to the controller’s
I/O Configuration folder.
DeviceNet Communication To communicate and exchange data with CIP Safety I/O modules on DeviceNet
networks, you need a 1756-DNB module in the local chassis.
For information on how to install your 1756-DNB module, refer to the
ControlLogix DeviceNet Scanner Module Installation Instructions, publication
1756-IN566.
The 1756-DNB module supports communication with DeviceNet Safety devices
and standard DeviceNet devices. You can use both types.
ControlNet
Distributed I/O
1756-CN2 Module (as an
Adapter) with 1756 I/O
Modules
1794-ACN15 Adapter with
1794 I/O Modules
Personal
Computer/
Workstation
GuardLogix Controller with
1756-CN2 Module
GuardLogix
Controller with
1756-DNB
Module
1734-ACNR Adapter with
1734 I/O Modules (1)
PanelView™ Terminal
PLC-5
®
/40C Controller
PowerFlex 700S AC
Drive with
DriveLogix Software
1756-DNB Module
to DeviceNet Network
with CIP Safety I/O
to DeviceNet Network
with CIP Safety I/O
Compact GuardLogix Controller with
1768-CNB Module